SAFETY EDGES
The sensitive edges, for automation safety, in particular for swing gates, sliding gates and overhead doors, are available in different sizes and with rigid or soft ends. The edge inside which there is the steel cable that tends the safety micro, is black with yellow inserts that make it visible when installed on the automation. Also available is the “hand protection edge” to be applied on the gates on the hinge side, to prevent the introduction of the fingers where the frank is greater than or equal to 25mm.
CSA
- Electromechanic safety edges
- 3 micro switches version on accordance witn EN954/1 norm
- PVC soft element with yellow inserts
- Lower side sensible to strokes
Available in the versions:
- CSA015 dim. H 150 cm
- CSA020 dim. H 200 cm
- CSA025 dim. H 250 cm
CSA
- Electromechanic safety edges
- 3 micro switches version on accordance witn EN954/1 norm
- PVC soft element with yellow inserts
- Lower side sensible to strokes
Available in the versions:
- CSA015 dim. H 150 cm
- CSA020 dim. H 200 cm
- CSA025 dim. H 250 cm
BS 10
- Sensitive electromechanical safety edges
- Soft and shock-sensitive ends
- 8.2 Kohm / NC cable connection
- SA 250V ac microswitch contact rating (EN61058-1)
- CLIP fixing
- IP54 protection
Available in the versions:
- BS 1015 dim. H 150 cm
- BS 1020 dim. H 200 cm
- BS 1025 dim. H 250 cm
CP 20
- Passive extruded edge in rubber and aluminum profile for overhead doors and swing gates
BPM
- Hand protection edge for swing gates and sectional doors.
Contact form
* Required fields
To get more information on the methods of processing your data and consents, consult our Privacy Policy . Armas informs that all personal data sent are considered strictly confidential. In compliance to art. 13 of law 675/96 you can, at any time, have access to these data and request their cancellation by writing to Armas.